Marine

Filter

Application

1. Back filling for foundry patterns (1)
2. fixtures (1)
3. Good wetting and impregnating. Pot life and cure time can be varied by using a mixture of H3 & H8 keeping the same mixing ratio. This can be used for thicker laminates. (1)
4. guages (1)
5. jigs (1)
6. large negatives (1)
7. very low shrinkage. (1)

Pot Life (200g, 25°C) minutes

1. 120 (1)
2. 160-220 (2)
3. 18-24 (1)
4. 20-25 (1)
5. 30-60 (1)
6. 300-360 (1)
7. 40-70 (1)
8. 5-6 (1)
9. 50-70 (2)
10. 60-80 (1)
11. 8-10 (1)
12. data (4)
13. n/a (16)
14. See TDS (6)

Cure Time (25°C) Hours

1. 12 (2)
2. 16-24 (1)
3. 20 (1)
4. 24 (7)
5. 24-48 (1)
6. 5-60 sec (1)
7. 60-90 mins (1)
8. data (4)
9. n/a (15)
10. See TDS (6)

Viscosity (25°C) mPa.s

1. 1100-1500 (2)
2. 150-250 (1)
3. 180-300 (1)
4. 20-40 (1)
5. 2000-3000 (1)
6. 250-450 (1)
7. 300-600 (2)
8. 450-650 (1)
9. 500-800 (1)
10. data (4)
11. n/a (15)
12. Paste (3)
13. See TDS (6)

HDT °C

1. 100 (2)
2. 103-109 (1)
3. 105 (1)
4. 108-112 (1)
5. 130 (2)
6. 133-139 (1)
7. 170 (2)
8. 50 (1)
9. 55 (1)
10. 56-60 (1)
11. 57-61 (1)
12. 59 (1)
13. 63-67 (1)
14. 68 (2)
15. 70-75 (1)
16. 70-80 (1)
17. 79-83 (1)
18. 80 (1)
19. 82-86 (1)
20. 88-92 (1)
21. data (3)
22. n/a (5)
23. See TDS (7)

Shore Hardness

1. 10D (1)
2. 44D (1)
3. 50D (1)
4. 54D (1)
5. 70-75D (1)
6. 70D (2)
7. 73D (1)
8. 74D (1)
9. 75D (2)
10. 76D (1)
11. 78-82D (3)
12. 82-87D (2)
13. 83-87 (1)
14. 83-87D (4)
15. 85-88D (1)
16. 87-92 (1)
17. data (4)
18. n/a (5)
19. See TDS (5)
20. TBC (1)