Formula 1
Products that are specifically designed and formulated for use in the Formula 1 industry.
Filter
- Industry
- Application
-
- Adhesive for M301 (1)
- Adhesive for M651 (1)
- durability and tear strength. For general mouldmaking where a hard rigid structure is required. (1)
- Good release properties (1)
- Good wetting and impregnating. Pot life and cure time can be varied by using a mixture of H3 & H8 keeping the same mixing ratio. This can be used for thicker laminates. (1)
- Low to medium pressure RIM where high strength is required (1)
- Low to medium pressure RIM where high strength is required. (1)
- Low to medium pressure RIM where high thermal properties are required. Under bonnet (1)
- Very low viscosity producing good wetting of fibres and fillers. (1)
- Pot Life (200g, 25°C) minutes
- Cure Time (25°C) Hours
- Viscosity (25°C) mPa.s
- HDT °C
- Shore Hardness