Vacuumforming and Thermoforming

Filter

Application

1. Back filling for foundry patterns (1)
2. Best selling resin system for Vacuum forming tools. large volumes can be cast with slow hardener. (1)
3. fixtures (1)
4. Good wetting and impregnating. Pot life and cure time can be varied by using a mixture of H3 & H8 keeping the same mixing ratio. This can be used for thicker laminates. (1)
5. guages (1)
6. jigs (1)
7. large negatives (1)
8. Pre- fabricated support frames and vacuum forming moulds. (1)
9. PU Foam Injection Tools. RIM Tools Foundry Patterns and Thermo-forming tools. (1)
10. Specifically formulated for vacuum forming Polycarbonate. (1)
11. very low shrinkage. (1)

Pot Life (200g, 25°C) minutes

1. 10-12 (1)
2. 100-140 (1)
3. 120 (1)
4. 120-180 (2)
5. 15-20 (1)
6. 30-50 (1)
7. 4-5 (1)
8. 40-70 (1)
9. 50-80 (1)
10. 60-70 (1)
11. 80 (1)
12. n/a (13)
13. See TDS (1)

Cure Time (25°C) Hours

1. 12 (1)
2. 12-16 (1)
3. 12-24 (2)
4. 24 (3)
5. 24h (2)
6. 30m (1)
7. 6-8 (1)
8. 8-14 (1)
9. n/a (13)
10. See TDS (1)

Viscosity (25°C) mPa.s

1. 1000-1500 (1)
2. 10000-15000 (1)
3. 12000-16000 (1)
4. 12000-18000 (1)
5. 1500 (2)
6. n/a (13)
7. Paste (2)
8. See TDS (1)
9. thixo (4)

HDT °C

1. 105 (1)
2. 108 (1)
3. 110 (1)
4. 110-120 (2)
5. 116 (1)
6. 125 (1)
7. 130 (1)
8. 150-160 (2)
9. 160 (1)
10. 55 (1)
11. 68 (2)
12. 70-80 (1)
13. 73 (1)
14. 75 (1)
15. 80 (2)
16. 90-95 (1)
17. n/a (4)
18. See TDS (1)
19. TBC (1)

Shore Hardness

1. 66 (1)
2. 70D (2)
3. 75D (2)
4. 76D (1)
5. 80-85 (1)
6. 80-85D (3)
7. 80D (2)
8. 81D (1)
9. 82D (1)
10. 83D (1)
11. 85D (1)
12. 87-92D (1)
13. 88-92 (1)
14. 88-93D (1)
15. 90-95D (1)
16. n/a (4)
17. See TDS (1)
18. TBC (1)